Consultez les proceedings de la Conference COMSOL 2024
Dr. Ivar Kjelberg is Senior Project Manager for Mechatronics in the Systems Engineering Division of CSEM SA in Neuchâtel, Switzerland. He obtained the diploma as \"Ingénieur Physicien\" from the Ecole Polytechnique Fédéreale EPFL in Lausanne, Switzerland in 1979, and a PhD at the local ... En savoir plus
Instrumented indentation is increasingly used as an alternative non-destructive test method to measure mechanical properties of small volumes of materials. In this work, the instrumented indentation test is applied as a non-destructive method to assess the mechanical properties of TiAl ... En savoir plus
3D electro-thermo-mechanical finite element model of power vertical MOSFET used in the automotive industry is presented in this paper. The presented paper is a qualitative study of power device results from electro-thermo-mechanical simulation. This study particularly interested in the ... En savoir plus
The study of deformation of an adhesively bonded sandwich structure reduces to solving the biharmonic equation for the Airy Stress subject to mixed boundary conditions. Because of the nature of the boundary conditions, this boundary value problem does not yield to the standard elementary ... En savoir plus
This paper will present a numerical model based on COMSOL Multiphysics suited to simulate the dynamic response of a catenary mooring (or a submarine cable). In general, mooring lines are subject to a direct wave load (e.g. drag, inertia) in addition to the movement of the vessel to ... En savoir plus
The contact between infinitely rigid body and deformable part is studied using the velocity as a dependent variable. A simple forging case is evaluated. The velocity approach is realized by means of using COMSOL with the Equation-Based Modeling. The contact model evaluated in this work ... En savoir plus
Powder metallurgy is a key technology for manufacturing advanced components based on TiAl alloys. Cold compaction is the primary step to produce green parts. Cold deformation of TiAl powder is difficult due to its typical poor ductility. Plastic deformation and cracking susceptibility of ... En savoir plus
It is very difficult to measure the global properties of heterogeneous and anisotropic materials like composites and sandwich structures. When designing composite sandwich applications, the elastic properties are required to perform structural stiffness and strength calculations. ... En savoir plus
Ultrasonic Testing (UT) is one of the important Non-Destructive Evaluation (NDE) technique widely used for characterisation of materials as well as detection and characterisation of flaws present in the material used in various industries. There are many different important materials ... En savoir plus
The tensile strength of masonry is relatively low compared to its compressive strength and is affected by the direction of the joints and their filling. In masonry with modern thin layer mortar (joint thickness 3 to 5 mm) sometimes the head joints are left open. A total of 13 model-walls ... En savoir plus