Consultez les proceedings de la Conference COMSOL 2024
The Oak Ridge National Laboratory (ORNL) is developing technology to re-establish the capability to produce plutonium-238 for the National Aeronautics and Space Administration (NASA) as a power source material for powering vehicles while in deep-space. The High Flux Isotope Reactor ... En savoir plus
Simulation models for steady state thermal hydraulics analyses of ORNL’s HFIR have been developed using COMSOL. A single fuel plate and coolant channel of each type of HFIR fuel element was modeled in three dimensions. The standard k-? turbulence model was used in simulating turbulent ... En savoir plus
This paper presents a novel design of single-bit RF MEMS phase shifter. The basic novelty introduced for phase shifter design in this case, is by scaling down of the lateral dimensions of the conventional RF MEMS shunt switch by 10 times. The Mechanical and Electromechanical analysis ... En savoir plus
COMSOL Multiphysics 4.0 is being used to simulate the free vibrations of a plate. The results obtained by simulation in COMSOL are in close proximity to that found by Fast Fourier Transform analyzer and analytical method. As of now the vibration analysis of thin rectangular plates with ... En savoir plus
In this paper, we present study on the mass loading effect of the interdigital transducer (IDT) on surface acoustic wave (SAW) velocity in SAW devices, using COMSOL Multiphysics. We have simulated a one port SAW resonator made on YZ lithium niobate substrate and investigated the ... En savoir plus
The objective of this paper is to design a 3D Gas Sensor for sensing Hydrogen gas and to increase the conductivity at nano level. In this novel design, nanorods act as the sensing layer. The sensitivity towards gas adsorption is found to be increased due to its high surface to volume ... En savoir plus
The present work aims to develop a blood pressure sensor using MEMS/NEMS technology. A normal blood pressure detector is used externally, but this work mainly aims for designing an implantable nanotube based sensor for continuous monitoring of blood pressure. The use of COMSOL ... En savoir plus
The main reason for stent implantation is to provide mechanical support to the arterial wall. So it is important to consider the different mechanical properties of different stent materials while studying the stent implant’s efficacy. The present study gives a comparative overview of ... En savoir plus
Two bimorph array facing opposite to each other are designed and attached with metal micro plates. The micro solar cell (or) film can be placed on the top of each plate for storing the energy. With respect to the direction of sun light, one bimorph array receives more energy in the form ... En savoir plus
A MEMS based Knudsen’s pressure gauge working in the range of 1e-5 mbar to 10 mbar is designed and simulated in COMSOL. The working principle is based on Knudsen’s forces that arise when two plates are held at different temperatures and their separation is comparable to the mean free ... En savoir plus