Consultez les proceedings de la Conference COMSOL 2024
This paper reports the structural solid mechanic simulation of a MEMS out-of-plane platform that provides thermal and electrical isolation for a device built on it. When assemble, the platform lifted for approximately 400 μm above the substrate level. A mechanical stress analysis is then ... En savoir plus
Computational tools based on the finite element method have been used extensively to develop solutions for elastic and elastic-plastic fracture mechanics problems. This work uses a small-scale yielding model to compare results developed from COMSOL Multiphysics® with another finite ... En savoir plus
Puffing of biomaterials involves mass, momentum and energy transport along with large volumetric expansion of the material. Development of physics-based models that can describe heat and moisture transport, rapid evaporation and large deformations can help understand the puffing process. ... En savoir plus
In this study, a model of in-situ geothermal energy piles was constructed using COMSOL Multiphysics® software. Geothermal energy piles serve two purposes, first to transfer building load into the subsurface, but also to extract thermal heat from surrounding soils. This is achieved using ... En savoir plus
Although cardiac arrest may be statistically insignificant event financial and more important emotional costs in such cases are quite devastating. In this paper we study the effects of multiple grounding pads. Namely, we believe that by placing multiple pads in the lower abdominal part ... En savoir plus
The design of a magnetic resonance imaging (MRI) RF coil using finite element method-based analysis is an essential part of a multi-year research project at the National Institute of Standards and Technology, Gaithersburg, Maryland, where the goal of the project is to develop a “phantom” ... En savoir plus
Introduction: In this work, a CFD model of 2D flow around a fully deployed flow actuator was developed using COMSOL Multiphysics® software and the CFD Module. The results of COMSOL modeling is also compared with the experimental data of the same dimensions actuator. The 100mmX2mm ... En savoir plus
In response to continued miniaturization and increased multi-functionality of electronic circuits, the number of integrated circuit (IC) packages on the circuit board continues to increase. As a consequence the operating power density increases and significant increases in the operating ... En savoir plus
This study analyzed the laser powder bed additive manufacturing process. The laser is modeled as a moving heat source with time dependent heat transfer causing local, transient melting of the metal powder. Heat transfer is considered to take place due to convection in the molten metal ... En savoir plus
A research team at FSU CAPS is developing a novel fast disconnect switch based on a piezoelectric actuator for use in next-gen electric power distribution systems. COMSOL Multiphysics® software was used to optimize geometry and material selection of the disconnect switch. Current ... En savoir plus