Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Meshing

Posted 26 oct. 2014, 14:59 UTC−4 Fluid & Heat, Computational Fluid Dynamics (CFD), Microfluidics, Geometry, Mesh 0 Replies

Arjun Dubhashi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I need to mesh a microfluidic model with different mesh sizes in different domains to save on computing time on the unimportant regions. Consequently, I've partitioned the model into different domains and used different mesh sizes in each. However, I keep getting an error that says, "failed to respect edge element on geometry edge"

I've tried subdividing this region into smaller domains but to no avail. Is there anything else I can do? Is there a edge specific refinement? I'm new to this.

Regards,

Arjun
0 Replies Last Post 26 oct. 2014, 14:59 UTC−4
COMSOL Moderator

Hello Arjun Dubhashi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content