Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Current Source and violation of Maxwell-Ampère’s law
Posted 3 janv. 2013, 00:29 UTC−5 Low-Frequency Electromagnetics, Battery Design, Materials, Modeling Tools & Definitions, Parameters, Variables, & Functions, Studies & Solvers Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
I have setup a model using both Electric Currents and distributed ODE and PDE interfaces using a simple 2D square geometry.
One boundary of the geometry is set as ground and another used to apply an external current density. I'm also injecting a current into the domain using the "Current Source" option. This current is formulated using a set of ODE equations.
The model solves but I am getting very large errors when validating the model using Kirchhoff's laws.
COMSOL's documentation state that the current source option should be used "with caution as it may violate the current conservation law that is inherent in Maxwell-Ampère’s law".
Has anybody had any similar experience using the Current Source? Did you observe any violations in Maxwell-Ampère’s law? If so how to work around this problem?
Hello Amr Al Abed
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.