Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

flux along -x

Posted 11 déc. 2012, 05:23 UTC−5 RF & Microwave Engineering, Parameters, Variables, & Functions Version 4.3 1 Reply

Sara Nocentini
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I am doing simulation on waveguides (2D simulation, vertical section).
I calculate the flux along a vertical line.
I would like to control the flux along -x to see if there are some reflections.

Does someone know how I can do?
Thank you very much

Sara Nocentini
1 Reply Last Post 11 déc. 2012, 05:48 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 11 déc. 2012, 05:48 UTC−5
Hi

I believe you should sketch out or add an image to let us better understand your issue, and do not forget to read carefully the Knowledge base articles about Flux calculations

--
Good luck
Ivar
Hi I believe you should sketch out or add an image to let us better understand your issue, and do not forget to read carefully the Knowledge base articles about Flux calculations -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content