Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Mode volume calculation of Photonic Crystal Defect
Posted 11 févr. 2020, 05:12 UTC−5 RF & Microwave Engineering, Wave Optics, Fluid & Heat Version 5.3a 0 Replies
Please login with a confirmed email address before reporting spam
I was trying to simulate a Photonic crystal defect in COMSOL. My model is a square array of dielectric cylinders in air matrix with a point defect at the center. I want to calculate the Q-factor and the mode volume of the defect. I can calculate the Q- factor from the reflection spectra using FWHM and the center frequency of the defect mode and also from the eigenvalue analysis applying scattering boundary conditions. But I’m getting different values for the same model.
Is there any way to calculate the mode volume directly from the model? I have tried by defining it in the variables. But I’m not sure about how to specify the position-dependent electric field intensity and dielectric permittivity etc.
Note: I’m attaching the equation for effective mode volume.
[https://drive.google.com/open?id=1sjek99_Oetp8aMkMUofjEpvp8Snx0Mu5](http://)
Hello Arun B
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.