Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to open a built model into another built model

Please login with a confirmed email address before reporting spam

Hi I am trying to make a wind tunnel and simulate a convertor in to that wind tunnel.
I have already made the convertor with all its heat generation. But can anyone tell me if I want to make another model of wind tunnel and place this convertor into the another model how to do it??

I tried but failed...

Thanks for you help in advance... I have comsol 4.0

1 Reply Last Post 19 nov. 2011, 09:34 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 19 nov. 2011, 09:34 UTC−5
Hi

I do not believe it's possible to "load in" a partial model into another, you must rebuild it.
I supose the main cause to be because there are so many formulas and variables, that there are a fair chance that the import will generate variable name collisions and other undesired couplings

--
Good luck
Ivar
Hi I do not believe it's possible to "load in" a partial model into another, you must rebuild it. I supose the main cause to be because there are so many formulas and variables, that there are a fair chance that the import will generate variable name collisions and other undesired couplings -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.