Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Phase change of water

Posted 14 août 2017, 07:34 UTC−4 Heat Transfer & Phase Change Version 5.3 0 Replies

Gyuhyun Go
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I made a one-dimensional model that simulates the phase change of water(ice to water).
The length of rod : 10 cm
The initial temperature:-10 degC,
The end point temperature: 10 degC
It means a ice-to-water phase change.
For this, I referred to below link:
www.comsol.com/model/phase-change-474
Attached is the file I made.

But now I would like to make a "water-to-ice" phase change model using phase change material module.
The length of rod : 10 cm
The initial temperature:10 degC,
The end point temperature: -10 degC

Then, how should I change the material properties of water and ice?
In this case, do you think the result would be mirror image based on the 0 degC compared to the result of first model?
Here, the result means the temperature at Top.
0 Replies Last Post 14 août 2017, 07:34 UTC−4
COMSOL Moderator

Hello Gyuhyun Go

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content