Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Selecting multiple selections
Posted 28 févr. 2011, 07:56 UTC−5 Geometry, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.1 3 Replies
Please login with a confirmed email address before reporting spam
I'm dealing with a complex geometry and to simplify it I have made a couple of different selections under "Model 1' > "Definitions", e.g.:
* Selection 1: Domain 1
* Selection 2: Domain 2, Domain 3, Domain 6
* Selection 3: Domain 4, Domain 5
* Selection n: Domain x, Domain y
* etcetera...
Now, I want to use the heat transfer module in different simulation on different domains, automatically without changing the selection sets:
For example:
* Simulation 1: ht.selection.set['sel1' 'sel3']
* Simulation 2: ht.selection.set['sel2' 'sel3']
I.e. is it possible to select multiple selections from the definitions section as domains to be used in e.g. heat transfer?
Regards,
Peter.
Please login with a confirmed email address before reporting spam
I do not believe so yet.
I have been asking for such possibilities by sending a suggestion demand to "support", but pls contribute also by reminding them that this is useful, then it might come in next release ;)
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Creating new selections as the union/intersection/etc of existing selections is in the plans for v4.2. Expect also a couple of new, implicit, ways to create selections.
Jeff
Please login with a confirmed email address before reporting spam
Peter