Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Pipe with smaller diameter at outlet?

Posted 15 avr. 2017, 21:21 UTC−4 Geometry Version 5.2 1 Reply

Victoria Lee
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Please see the attached file for the very simple model of fluid flow I'm trying to simulate. I'm getting stuck on how to make the 0.1 cm opening.

Steps I've taken so far -

1. Made a 2D axisymmetrical component.
2. Added a rectangle of width = 2 cm, height = 3 cm.
3. Added a rectangle of width = 0.5 cm, height = 1 cm.
4. Union of Rectangle 1 and Rectangle 2.

Thanks in advance!

Attachments:

1 Reply Last Post 17 avr. 2017, 02:23 UTC−4
Tae Eun Kim
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 17 avr. 2017, 02:23 UTC−4
I think you make your model like this.
I think you make your model like this.

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content