Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

simulating an imported mesh (from matlab)

Please login with a confirmed email address before reporting spam

Hi,
I'm trying to simulate a prescribed displacement (one end is fixed and the other one displaced) of a mesh created in matlab (the geometry is from a microCT image). The problem is comsol dons't recognize the different surfaces. I used the box option in the mesh, but then the displacement is all messed up.
anyone has an experience with an imported mesh?
Thanks,
Shira

1 Reply Last Post 1 juin 2016, 04:26 UTC−4
COMSOL Moderator

Hello Shira Landau

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 8 years ago 1 juin 2016, 04:26 UTC−4
Hi !

I have the same problem .. did you find any solutions ?

Thanks,
Anais.
Hi ! I have the same problem .. did you find any solutions ? Thanks, Anais.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.