Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary Load Change Having No Effect.

Posted 24 nov. 2015, 13:07 UTC−5 Geometry, Structural Mechanics Version 5.1 4 Replies

Waseem Aldeek
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there,

I am new to COMSOL and still learning it's functionality. I am trying to apply a strain on the 4 fan edges (boundaries 13,14,18,20,29,30,43,44) of my structure and view it's resulting von Mises stress in the centre.

My problem is that no matter what value i enter as the boundary load, the resulting structure is always stretched by the same amount (20 microns) which is not correct. Any thoughts on what i am doing wrong would be greatly appreciated.

(As added information.... my goal is to simulate a 0.2% biaxial strain on the whole structure and view the von Mises stress profile in the centre of the structure.)

Attachments:

4 Replies Last Post 24 nov. 2015, 14:25 UTC−5
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 24 nov. 2015, 13:19 UTC−5
Your model is fine and responds linearly to the loading, as expected. See my post here: www.comsol.com/community/forums/general/thread/95633/#p217482
Jeff
Your model is fine and responds linearly to the loading, as expected. See my post here: http://www.comsol.com/community/forums/general/thread/95633/#p217482 Jeff
Waseem Aldeek
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 24 nov. 2015, 13:35 UTC−5
Thanks Jeff,

Is there anyway to change how the model is displayed post loading, to show a less "stretched" and more realistic structure?

Thanks again!
Thanks Jeff, Is there anyway to change how the model is displayed post loading, to show a less "stretched" and more realistic structure? Thanks again!
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 24 nov. 2015, 13:52 UTC−5
Yes, you can change the scaling factor to any value you choose. See screenshot attached.
Jeff
Yes, you can change the scaling factor to any value you choose. See screenshot attached. Jeff

Attachments:

Waseem Aldeek
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 24 nov. 2015, 14:25 UTC−5
Thank you, this has solved my issue.
Thank you, this has solved my issue.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content