Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Maxwell Stress in Version 4.4

Posted 5 nov. 2015, 15:09 UTC−5 Low-Frequency Electromagnetics, Modeling Tools & Definitions, Parameters, Variables, & Functions, Results & Visualization 0 Replies

Shahin Pajoom
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am using version 4.4 and simulating a droplet inside of another droplet in the presence of a magnetic field. The goal is to find the Maxwell stress on the surface of the droplet. In my geometry I am using a 2D axisymmetric model. The arrow plot shows that the maxwell stress is minimum at angle 0 (from the vertical axisymmetric axis) and is maximum at angle 90. However, when I make a line plot of the maxwell stress on the surface versus the angle, I notice that the maximum happens at 45 degree and the maxwell stress at 90 degree is zero. This contradicts the arrow plot and I have no explanation for it. I am using the downward Maxwell stress, while in version 4.3 I was using the upward Maxwell stress and the results of the two plots were matching. I was wondering if I am using the right Maxwell stress in this version, or there is a trick to it, or if anyone had suggestions or similar experience that could help me.

Thanks

Attachments:

0 Replies Last Post 5 nov. 2015, 15:09 UTC−5
COMSOL Moderator

Hello Shahin Pajoom

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content