Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Errors in Comsol solver

Posted 27 oct. 2015, 07:54 UTC−4 Microfluidics 0 Replies

Yusuf Dewantoro Herlambang
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

I am trying to simulate electrochemical reactions in porous media for fuel cell.
I have been run my model until 50% in progress but suddenly stopped, there is information about the error as follows:

Failure to find solutions of all parameters
Even minimum parameters scan
Returns the solution does not converge
  - Characteristics: Steady State Solver 1 (sol1 / s1)

What does means the above errors? Could you give me some suggestions?

Regards,
Yusuf
0 Replies Last Post 27 oct. 2015, 07:54 UTC−4
COMSOL Moderator

Hello Yusuf Dewantoro Herlambang

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content