Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how to use two boundary conditions at same boundary

Posted 22 sept. 2015, 04:20 UTC−4 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 5.0 1 Reply

Neeraj Jagtap
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have been solving darcy's module in which i am supposed to add BCS of inlet pressure as well as mass flux which is at same boundary. But when i add 1 boundary condition it gets overridden by another one. Since i want to use both data in my model iss there any method to add both bcs at same place?
1 Reply Last Post 26 avr. 2016, 20:53 UTC−4
COMSOL Moderator

Hello Neeraj Jagtap

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Di Shen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 26 avr. 2016, 20:53 UTC−4
Hi Neeraj,

I am doing a very similar problem and I also want to use a pressure BC and a Mass Flux BC on the same inlet. Have you figure out how to do it in comsol?

Many thanks
Di Shen
Hi Neeraj, I am doing a very similar problem and I also want to use a pressure BC and a Mass Flux BC on the same inlet. Have you figure out how to do it in comsol? Many thanks Di Shen

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content