Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Error: 5028 " Port is not coaxial"

Posted 16 août 2010, 18:26 UTC−4 0 Replies

Amit Mhatre
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam


I got this message when assigning a port boundary condition in coaxial cable. Below a certain magnitude of radius of the inner conductor( around 0.009") Comsol did not recognize the port as coaxial.

I increased the size of the inner conductor and accordingly changed the dielectric OD to keep the internal impedance to 50 ohms. Then above 0.012 it recognized the port as coaxial.

Is there a way to run the simulation with the real dimensions with out getting the error.
0 Replies Last Post 16 août 2010, 18:26 UTC−4
COMSOL Moderator

Hello Amit Mhatre

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content