Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Geometry issue
Posted 10 juin 2015, 06:42 UTC−4 Geometry Version 4.4 2 Replies
Please login with a confirmed email address before reporting spam
Dear all,
I am designing an encapsulation for a chip and I need to create a flow path through it.
The starting surface of the flow path is a circular surface and it should finish in a rectangular surface.
I am trying to figure out how to do this but I have not had success on this.
If somebody could help, it would be great.
Attached there is a picture of the design and in red you will find the surface that I want to unify.
Best regards,
Accel
I am designing an encapsulation for a chip and I need to create a flow path through it.
The starting surface of the flow path is a circular surface and it should finish in a rectangular surface.
I am trying to figure out how to do this but I have not had success on this.
If somebody could help, it would be great.
Attached there is a picture of the design and in red you will find the surface that I want to unify.
Best regards,
Accel
Attachments:
2 Replies Last Post 12 juin 2015, 08:16 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
I think the easiest way is to build this in a CAD program like Creo and do a swept blend.
Please login with a confirmed email address before reporting spam
Posted:
9 years ago
Hi,
Thanks for your reply. I think you are right, I already changed to SolidWorks to design the structure.
Cheers
Accel
Thanks for your reply. I think you are right, I already changed to SolidWorks to design the structure.
Cheers
Accel