Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Reposition or mover around imported parasoild geometry?

Posted 4 août 2010, 15:28 UTC−4 1 Reply

Sang Ha Shin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi.

Just wondering if there is a way to reposition imported parasolid geometries....

I have two imported parasolids under the same Geometry1 and want to change the orientation between the two.

Is this possible?

If not, is there a way around this?
1 Reply Last Post 4 août 2010, 16:51 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 4 août 2010, 16:51 UTC−4
Hi

at least in V4 you can rotate a body/volume

--
Good luck
Ivar
Hi at least in V4 you can rotate a body/volume -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content