Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

COMSOL only solves one multiphysics

Posted 29 juil. 2010, 15:40 UTC−4 1 Reply

Aaron Ross
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I've been trying to run a simulation of a proton source in COMSOL. Everytime I've attempted to run the simulation, only the electrostatic data is returned. Judging from the log, both segregated solvers were run, yet only the electrostatic data is available. I've attached the file below.

Thanks,
Aaron
1 Reply Last Post 1 août 2010, 07:46 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 1 août 2010, 07:46 UTC−4
Hi
I cannot load your file, neither in 3.5 nor 4, try to remove the solution (and mesh ?) and re-post it.
In anycase check your "save for" in the solver manager, this might be a clue

--
Good luck
Ivar
Hi I cannot load your file, neither in 3.5 nor 4, try to remove the solution (and mesh ?) and re-post it. In anycase check your "save for" in the solver manager, this might be a clue -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content