Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Quick build of all meshes in Parameter Sweep?
Posted 14 mai 2015, 08:42 UTC−4 Geometry, Mesh Version 5.0 3 Replies
Please login with a confirmed email address before reporting spam
COMSOL'ers:
Is there a way to quickly build all the meshes over a parameter sweep, without running through the computational steps in the study?
At a certain parametrized geometry, I am getting a failure. I know how to refine the mesh to fix it, but I do not know if these changes will then affect all the other parametrized models. Also, being able to test the mesh for all parameters will allow me to quickly optimize for minimal mesh size (pending solution convergence).
Thanks!
-Ado
Is there a way to quickly build all the meshes over a parameter sweep, without running through the computational steps in the study?
At a certain parametrized geometry, I am getting a failure. I know how to refine the mesh to fix it, but I do not know if these changes will then affect all the other parametrized models. Also, being able to test the mesh for all parameters will allow me to quickly optimize for minimal mesh size (pending solution convergence).
Thanks!
-Ado
3 Replies Last Post 14 mai 2015, 17:25 UTC−4
Please login with a confirmed email address before reporting spam
Posted:
10 years ago
Hello Bryan,
Sure, you can just disable any and all physics branches in your model. See attached toy example.
Jeff
Sure, you can just disable any and all physics branches in your model. See attached toy example.
Jeff
Attachments:
Please login with a confirmed email address before reporting spam
Posted:
10 years ago
Thank you, Jeff--nice that there is an easy solution.
I could not load your example--I am at 5.0, and it seems your file is 5.1 (states it was created with a later version). Nevertheless, with your advice, I was able to successfully run a sweep and survey each mesh, so I would consider that a success!
-Ado
I could not load your example--I am at 5.0, and it seems your file is 5.1 (states it was created with a later version). Nevertheless, with your advice, I was able to successfully run a sweep and survey each mesh, so I would consider that a success!
-Ado
Please login with a confirmed email address before reporting spam
Posted:
10 years ago
Yes, it works the same in 5.0 and 5.1.
With that said, if it's up to you, upgrade to 5.1; it's got lots of new goodies (see www.comsol.com/release/5.1).
Jeff
With that said, if it's up to you, upgrade to 5.1; it's got lots of new goodies (see www.comsol.com/release/5.1).
Jeff