Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Poroelasticity and fluid pressure

Posted 12 mai 2015, 14:49 UTC−4 Version 5.1 0 Replies

Kimia Mortezaei
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I have a question about poroelasticity interface in COMSOL. I modeled a reservoir under ground in which fluid is injected. I modeled the injection as mass flux. So I expected that the effective stress decreases by applying mass flux and increasing pore pressure. BUT, since all the initial stresses are compression and they have negative sign the stresses are added to the pore pressure instead of subtraction (effective stress= -stress-porepressure). So it help the stability of my model which is not true. Do you have any idea what should I do with this problem?

Thank you,
0 Replies Last Post 12 mai 2015, 14:49 UTC−4
COMSOL Moderator

Hello Kimia Mortezaei

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content