Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Stationary Study and Time Dependent Study of Same Model Disagree

Please login with a confirmed email address before reporting spam

Hi,

I'm running an electric currents interface for a dielectric board with a couple ground points and a constant current source within the dielectric. I'm interested in the transient solution to this problem (how the voltage approaches steady state) so I'm running a time dependent study.

To generate initial conditions for my time dependent study, I also ran a stationary study for my current source x 10^-6. I used the solution of the stationary study as the initial conditions for my time dependent study. To check the results of my time dependent study, I also ran the stationary study with the correct current source. The steady state solution of my time dependent study significantly disagrees with the solution of the stationary study.

Does anyone know what my problem is? I suspect it has to do with the initial conditions.

Thanks!
James

0 Replies Last Post 30 avr. 2015, 19:50 UTC−4
COMSOL Moderator

Hello James Chinn

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.