Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

failed to create mesh for a thin MEMS device

Posted 22 mars 2015, 15:34 UTC−4 MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Mesh Version 5.0 0 Replies

Harry Ge
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

My device is thin and contain two "inner block" in the arms, so the meshing become difficult. Are there any efficient solution to create mesh?

I may use extremely fine but the speed become extremely slow...

0 Replies Last Post 22 mars 2015, 15:34 UTC−4
COMSOL Moderator

Hello Harry Ge

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content