Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to draw ID picture of one point???

Posted 26 janv. 2015, 04:06 UTC−5 Version 4.4 2 Replies

Shirley Long
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have made a 1D model to calculate the concentration at the effluent point like the picture in the attachment. The x coordinate is time and the y is the concentration at the effluent point. But I can only achieve the concentration of the whole point but not the point.
How can I achieve this ??
Tks!!!!
2 Replies Last Post 26 janv. 2015, 07:27 UTC−5
Lasse Murtomäki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 26 janv. 2015, 07:06 UTC−5
I do not understand your question. What would you like to plot? At a particular time or across the entire domain?

Lasse
I do not understand your question. What would you like to plot? At a particular time or across the entire domain? Lasse
Shirley Long
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 26 janv. 2015, 07:27 UTC−5
Hello Lasse,

I just used the Point Probe to obtain the change of c with time at a given point.

It can achieve this. Thank you.

Shirley
Hello Lasse, I just used the Point Probe to obtain the change of c with time at a given point. It can achieve this. Thank you. Shirley

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content