Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Mesh Control Edge option is not available in Comsol version 4.2

Posted 19 nov. 2014, 16:50 UTC−5 Geometry, Mesh, Modeling Tools & Definitions Version 4.2 1 Reply

Appala Reddy Atchi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi... I could not find the option Mesh Control Edges (Virtual Operations). I was working to find flow over an airfoil and got stuck in the middle as this option is not available in the version 4.2 . Can someone please tell me an alternative for this option. Looking forward for suggestions. Thank you in advance.
1 Reply Last Post 20 nov. 2014, 08:38 UTC−5
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 nov. 2014, 08:38 UTC−5
Hello,
Mesh Control operations were introduced at version 4.3 (See this link: www.comsol.com/products/4.3/). We'd recommend updating your installation since there was no direct equivalent to that functionality prior to 4.3.
Best,
Jeff
Hello, Mesh Control operations were introduced at version 4.3 (See this link: http://www.comsol.com/products/4.3/). We'd recommend updating your installation since there was no direct equivalent to that functionality prior to 4.3. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content