Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How do you calculate mode overlap factors in 3D waveguide when supplies have two wavelengths using comsol multiphysics

Posted 11 nov. 2014, 01:30 UTC−5 2 Replies

Amit Sharma
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am designing a 3D wave guide using comsol multiphysics as core (Silicon nanocrystal and Sio2 composite refractive index is 1.595,length=100nm,width=300nm,height=100nm) and cladding (silicon refractive index 3.48,length=100nm,width=300nm,height=200nm).

At the input end I want to provide two supplies; pump (power=.3 and wavelength=1434nm) and signal (power=.003 and wavelength=1550nm).

Then I want to calculate mode overlapping factor between (signal and signal,pump and pump,signal and pump,pump and signal).

2 Replies Last Post 15 nov. 2016, 09:02 UTC−5
COMSOL Moderator

Hello Amit Sharma

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

明德 李
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 15 nov. 2016, 07:59 UTC−5
Could you tell me how to add the pump,thank you !!
Could you tell me how to add the pump,thank you !!
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 15 nov. 2016, 09:02 UTC−5
Hello AMit,
I believe you may be looking for the "with" operator. See Reference Manual for COMSOL Multiphysics, version 5.2a, page 250.
Best,
Jeff
Hello AMit, I believe you may be looking for the "with" operator. See Reference Manual for COMSOL Multiphysics, version 5.2a, page 250. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content