Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Metal-dielectric matrial interface

Posted 6 nov. 2014, 23:01 UTC−5 RF & Microwave Engineering Version 4.3b 1 Reply

Krupali
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I want to design a dielectric block inside circular waveguide.our model is not time dependent,only frequency dependent so i want to use RF module.so,can any one tell me how to interface metal and dielectric?
1 Reply Last Post 9 nov. 2014, 14:00 UTC−5
Robert Koslover Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 9 nov. 2014, 14:00 UTC−5
Sounds like a relatively-straightforward type of RF model. What kind of issue or problem is causing trouble? Use Comsol's tools for specifying geometry, material properties, and boundary conditions, to put the metal and dielectric into your model. Open and study some of the included RF module library examples to learn more.
Sounds like a relatively-straightforward type of RF model. What kind of issue or problem is causing trouble? Use Comsol's tools for specifying geometry, material properties, and boundary conditions, to put the metal and dielectric into your model. Open and study some of the included RF module library examples to learn more.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content