Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Heat transfer, Solid Mechanics and Laminar Flow

Posted 15 juil. 2014, 15:52 UTC−4 MEMS & Nanotechnology, Fluid & Heat, Heat Transfer & Phase Change, MEMS & Piezoelectric Devices, Microfluidics, Modeling Tools & Definitions, Parameters, Variables, & Functions, Structural Mechanics Version 4.4 0 Replies

Marwan Nafea
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

What are the required physics to be used when designing a micropump that works using heat?
When the surface is being heated up, the liquid expands and pumps out.
It should be noticed that the micropump will deform also when it is being heated up.

So, what should I use in this case?

- Heat Transfer and Solid Mechanics.
- Heat transfer, Solid Mechanics and Laminar Flow.

Any suggestions?

Best regards,
Marwan
0 Replies Last Post 15 juil. 2014, 15:52 UTC−4
COMSOL Moderator

Hello Marwan Nafea

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content