Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem by generating a mesh

Please login with a confirmed email address before reporting spam

Hey everyone,

Firstly I want to say that I am a total beginner in COMSOL.

I got an WEY-piece and shall simulate a flow (of air) through this piece. I chose the k-omega turbulent flow physics, then imported the geometry by an .stl file and generated an physic-controlled mesh. Unfortunately I got the attached error message and I am a bit helpless.

I guess it is a problem with the model, because I can not see a mesh over every part of the model.

I wanted to attach the model too but I got an error at the try "file extension error"
So here is the file in an dropbox folder: www.dropbox.com/s/pclupnzz4lniupm/Y-WAY_875_flow_merged_2.stl

I hope anyone can help me

Best wishes
Benedikt



0 Replies Last Post 4 juin 2014, 04:28 UTC−4
COMSOL Moderator

Hello Benedikt Simon

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.