Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Ramp fuction or?
Posted 30 avr. 2014, 02:51 UTC−4 Fluid & Heat, Heat Transfer & Phase Change, Parameters, Variables, & Functions, Studies & Solvers Version 4.3b, Version 4.4 0 Replies
Please login with a confirmed email address before reporting spam
I am simulating heat transfer with fluid flow, thus I need to slowly increase my heat source to make my simulation works. Until now I've been using step function but I feel liek ramp function fits it better. Id like to have my heat source value increasing from 0 to 100% in 20% of the time of simulation, then to stay at this level.
I'm not sure if I am doing correctly. For example, I have my heat source 1000 kw/m3 and 300 s time simulation. Should I set slope as: 1000/0.2*300 and cutoff: 0.2*300 ?
And then set my heat source as 1000*rm1(t[1/s])?
I appreciate any help cause I'm little confused now.
Hello Bolesław Bródka
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.