Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Changing units of geometry for an imported model

Posted 17 mars 2014, 09:26 UTC−4 Geometry 0 Replies

Naresh Chowdary
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I hope some body could answer the following questions.

Is it possible to change the units of geometry for an imported model ?

If yes then is it possible to get desired units in "Cut Line 3D "

Thanks in advance.
0 Replies Last Post 17 mars 2014, 09:26 UTC−4
COMSOL Moderator

Hello Naresh Chowdary

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content