Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Phase change effect in Simulation

Lele, Dipl.-Phys. & Msc.

Please login with a confirmed email address before reporting spam

Dear Comsol Users,

I would like to know if someone here has already deal with phase change effect in the simulation. I mean, like water phase change from liquid to gas --> showing the pressure and mass evolution. If it is the case, please just give me some hints that could help me. I use the Chemical Engineering and Heat Transfer Modules.

Thanks in advance for your help.
Cheers,

--
A. Fopah Lele
Dipl.-Phys. & Msc.

0 Replies Last Post 5 mars 2014, 04:49 UTC−5
COMSOL Moderator

Hello Lele, Dipl.-Phys. & Msc.

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.