Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
mutual coupling waveguides
Posted 22 juil. 2013, 07:49 UTC−4 Version 4.2 0 Replies
Please login with a confirmed email address before reporting spam
I am trying to model two oppositely located waveguides for heating fluids. I am using 4.2, Electromagnetic waves in RF module and non-isothermal module in heat transfer module.
I am trying to simulate whole model in 3D.
I am using following boundary conditions for emw;
Port (for mutual coupling waveguides)
Scattering boundary condition (for inlet and outlet)
Impedance boundary condition (metal boundaries)
When I run the program I had a wrong solution. Because of mutual coupling the waves can interfere each other (I am not exactly sure it is because of that) . But I don´t know what will I do about this. I must use boundary conditions except these boundary conditions or something else?
I couldn´t find any topic about this. Can anyone help me please?
' I attached my model in attachements.
Attachments:
Hello Sezin Tuta
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.