Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

parametric sweep stops when encountering error

Posted 28 juin 2013, 04:30 UTC−4 Version 4.3, Version 4.3a, Version 4.3b 0 Replies

sebastian
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm a COMSOL newby and have just gotten into the concept of parametric sweeps. At the moment, I'm running parametric sweeps for fluid flows on a simple rectangular domain. What annoys me, however, is that the parametric sweep stops whenever an error (i.e. solution does not converge for a combination of parameters) occurs. Is there a way to tell the parametric sweep to continue running, even if it runs into an error for a single set of parameters?
0 Replies Last Post 28 juin 2013, 04:30 UTC−4
COMSOL Moderator

Hello sebastian

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content