Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulation of Autoclave environment for curing of Carbon epoxy composites

Posted 21 juin 2013, 14:03 UTC−4 Fluid & Heat, Heat Transfer & Phase Change, Chemical Reaction Engineering, Modeling Tools & Definitions, Parameters, Variables, & Functions Version 4.2, Version 4.2a, Version 4.3, Version 4.3a, Version 4.3b 0 Replies

Shivam Asthana
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

How to simulate heat and fluid physics as we see in autoclave for curing of composites
0 Replies Last Post 21 juin 2013, 14:03 UTC−4
COMSOL Moderator

Hello Shivam Asthana

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content