Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Apply load to a deformed mesh/geometry

Posted 2 juin 2013, 17:43 UTC−4 Geometry, Mesh, Studies & Solvers, Structural Mechanics Version 4.3b 0 Replies

maidou
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have applied load to a hypeelastic material model for a stationary structural analysis and I have gained the deformed result. I am trying to apply the second load to the deformed boundary on the basis of the previous deformed shape. I am not quite sure what approach I should use.
1. I tried to export the deformed mesh and started a new simulation, but I had problem to export the nodal solution and to apply the pressure on the deformed boundary.
2. I tried to apply load by step, i.e. load=pressure*n, (n=1,2), it works when pressure is low and it starts showing error when loads increases too much. Has anyone had experience to similar problem ? Thank you.
0 Replies Last Post 2 juin 2013, 17:43 UTC−4
COMSOL Moderator

Hello maidou

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content