MEMS Gyroscope Heater

Please login with a confirmed email address before reporting spam

Hello,

I was wondering if it is possible to combine a microheater simulation with a mems gyroscope simulation. I have two separate MPH files with different simulations. Would I just recreate the heater geometry in my MEMS gyro simulation and create two boundaries? How can I use the subsequent resultant heat from the heater to be applied to the MEMS gyro? Would it make more sense to take that resultant heat value and apply a thermal boundary on the MEMS itself?


Reply

Please read the discussion forum rules before posting.

Please log in to post a reply.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.