Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Running a specific Study node using batch

Posted 10 janv. 2013, 11:44 UTC−5 Version 4.4 3 Replies

J
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I would like to run a specific Study node (suppose I have a model with 2 or more Study nodes) using batch commands. Normally I write something like

comsol -nn 8 -np 8 batch -inputfile input.mph -outputfile output.mph -batchlog batch.log

Does anyone know which additional command I should issue to be able to select a specific Study node to run?

Best,

J
3 Replies Last Post 29 sept. 2014, 22:01 UTC−4
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 janv. 2013, 16:54 UTC−5
Doctor J,

Simply type:

comsol -nn 8 -np 8 batch -inputfile input.mph -outputfile output.mph -study <study tag> -batchlog batch.log

You can even specify which parameters to solve for and their values from the command line if you wanted using -pname and -plist.

Check out pgs 95 and 96 of the Installation and Operations Guide for more COMSOL Batch Commands.

Hope that helps.

Regards,
Josh Thomas
AltaSim Technologies



Doctor J, Simply type: comsol -nn 8 -np 8 batch -inputfile input.mph -outputfile output.mph -study -batchlog batch.log You can even specify which parameters to solve for and their values from the command line if you wanted using -pname and -plist. Check out pgs 95 and 96 of the Installation and Operations Guide for more COMSOL Batch Commands. Hope that helps. Regards, Josh Thomas AltaSim Technologies
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 10 janv. 2013, 16:58 UTC−5
Oh, if you don't know the <study tag>...right-click on the main Study node and select Properties from the list. The Settings window will give you the tag. For example, std1 or std2, etc.

Regards,
Josh Thomas
AltaSim Technologies
Oh, if you don't know the ...right-click on the main Study node and select Properties from the list. The Settings window will give you the tag. For example, std1 or std2, etc. Regards, Josh Thomas AltaSim Technologies
Weijia Cui
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 29 sept. 2014, 22:01 UTC−4
Hi，
What if I want to get output of one node?
For example, I want to know the temperature of a node and I know the tag of this node is tag1.
What command should I type for this?


THX
Hi， What if I want to get output of one node? For example, I want to know the temperature of a node and I know the tag of this node is tag1. What command should I type for this? THX

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content