Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Create Probing Surface then Surface Integrate over it
Posted 20 déc. 2012, 15:14 UTC−5 Fluid & Heat, Parameters, Variables, & Functions Version 4.3, Version 4.3a 1 Reply
Please login with a confirmed email address before reporting spam
Good evening Ladies and Gentlemen!
I'm working with a 3D fluid flow model, and I want to find the mass flow rate through an arbitrary cross section of the flow. How can I create a surface that can then be integrated across to get mdot = rho*velocity*area? I am easily able to integrate with the "Derived Values" --> "Integration" --> "Surface Integration" command, but I do not know how to create a selectable surface at any arbitrary cross section!
Thanks,
TEB
I'm working with a 3D fluid flow model, and I want to find the mass flow rate through an arbitrary cross section of the flow. How can I create a surface that can then be integrated across to get mdot = rho*velocity*area? I am easily able to integrate with the "Derived Values" --> "Integration" --> "Surface Integration" command, but I do not know how to create a selectable surface at any arbitrary cross section!
Thanks,
TEB
1 Reply Last Post 20 déc. 2012, 15:32 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
easiest, I would say is to define the surface via a Boolean function on a Data Set "cut plane", if you cannot define it front up via a boundary
--
Good luck
Ivar
easiest, I would say is to define the surface via a Boolean function on a Data Set "cut plane", if you cannot define it front up via a boundary
--
Good luck
Ivar