Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

boundary condition that depends on the position

Posted 20 déc. 2012, 11:20 UTC−5 Fluid & Heat, Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD), Chemical Reaction Engineering Version 4.2a, Version 4.3 1 Reply

Valeri Bubnovich
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

good afternoon
I need to enter a boundary condition in Heat Transfer that depends on the position,
what should I do?
thanks
1 Reply Last Post 20 déc. 2012, 13:52 UTC−5
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 20 déc. 2012, 13:52 UTC−5
Hi

check the FORUM it has been discused a few times, you can write (for most BC fields) for example:

Amplitude * ( x / Length )

--
Good luck
Ivar
Hi check the FORUM it has been discused a few times, you can write (for most BC fields) for example: Amplitude * ( x / Length ) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content