Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Phase Change Material

Posted 13 janv. 2024, 08:15 UTC−5 Version 6.2 1 Reply

Beatriz Perez
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello! I want to implement a Phase Change Material to run a simulation but I don't know where to find it. Some time ago, I was using an older version of COMSOL and I could find it under the heat transfer in fluids, but it isn't there now in the 6.2 version.

Thanks!

1 Reply Last Post 15 janv. 2024, 08:53 UTC−5
Andrii Grytsan COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 10 months ago 15 janv. 2024, 08:53 UTC−5

Hi Beatriz,

You can find Phase Change Material if you right-click on the "Heat Transfer in Fluids" subnode "Fluid 1" in your Model Builder tree. As an alternative, you can find it in the Ribbon Menu on Physics Tab, in its Attributes section.

Best regards, Andrii Grytsan

Hi Beatriz, You can find Phase Change Material if you right-click on the "Heat Transfer in Fluids" subnode "Fluid 1" in your Model Builder tree. As an alternative, you can find it in the Ribbon Menu on Physics Tab, in its Attributes section. Best regards, Andrii Grytsan

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content