Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

A question about complex meshes

Posted 5 juil. 2023, 22:24 UTC−4 Mesh Version 6.1 1 Reply

PeiJun Qin
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am confused as to how I should create mesh if the geometry of the model is a large cylinder (say 4000 cm in diameter) with many very small and dense (1000) cylinders (5-15 cm in diameter) inside. They are exactly the same length.

Best Regards

1 Reply Last Post 6 juil. 2023, 08:01 UTC−4
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 year ago 6 juil. 2023, 08:01 UTC−4

Hi Peijun,

in complex geometries I start with meshing the small domains and work towards the larger connecting domain. You will probably need to customize the meshes according to the requirement of the model physics. Try to work with selections to handle large numbers of domains. Try to apply symmetries if possible. Check if a 3D model can be reduced to 2D.

Cheers Edgar

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Hi Peijun, in complex geometries I start with meshing the small domains and work towards the larger connecting domain. You will probably need to customize the meshes according to the requirement of the model physics. Try to work with selections to handle large numbers of domains. Try to apply symmetries if possible. Check if a 3D model can be reduced to 2D. Cheers Edgar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content