Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Measurements of conductivity in graphene

Posted 11 juil. 2012, 07:36 UTC−4 Low-Frequency Electromagnetics, MEMS & Nanotechnology, MEMS & Piezoelectric Devices 2 Replies

Julien Paparone
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,
I'm studying the conductivity of a graphene-based device depending on the gate voltage applied on it. The thing is, to perform the simulation, Comsol requires a value for the conductivity, which is precisely the thing I want it to calculate.
Any suggestions ?
Thanks by advance.
2 Replies Last Post 23 juin 2016, 01:48 UTC−4
COMSOL Moderator

Hello Julien Paparone

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Mohammad Farzaneh
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 22 juin 2016, 01:17 UTC−4
As far as I know, material library of COMSOL does not provide graphene physical model. You need to calculate it numerically using either simple Drude model or more sophisticated Kubo formulation.
As far as I know, material library of COMSOL does not provide graphene physical model. You need to calculate it numerically using either simple Drude model or more sophisticated Kubo formulation.
Daniel Connelly
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 8 years ago 23 juin 2016, 01:48 UTC−4
If you treat it as a semiconductor you'd need a carrier mobility, not a conductivity. You should be able to model it as a semiconductor.
If you treat it as a semiconductor you'd need a carrier mobility, not a conductivity. You should be able to model it as a semiconductor.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content