Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Using model boundaries, not domains, for heat source
Posted 2 août 2021, 04:46 UTC−4 Heat Transfer & Phase Change, Geometry, Modeling Tools & Definitions 2 Replies
Please login with a confirmed email address before reporting spam
Hello,
Is it possible to somehow use the model boundaries instead of the domains to define the heat source parameters?
The domain selects too many different features, with boundary in other nodes I can selecte specific parts of the model
Edit: I have created an explicit selection using 'Boundary' as the geometric entity level, but in the Heat Source node (Under Heat Transfer in Solids), there is still no option to select it.
Thanks in advance!
Hello Samuel Rorison
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Try using heat flux in the same physics
Please login with a confirmed email address before reporting spam
Allow me to expand a little William's answer: a volumic heat source in a domain transforms into a heat flux when the heat source comes from a boundary. In a 3D problem, on a boundary the heat flux is W/m^2 whereas in the same problem a heat source that is for instance distributed in a domain is in W/m^3.
-------------------Eric Favre
COMSOL France