Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

boundary condition

Please login with a confirmed email address before reporting spam

Hi
dear Mr evar


I did not understand for what the output voltage is not symmetrical
and what does not has a voltage of 1V is ready (as calculated theoretical value)?

Thank you.


1 Reply Last Post 11 juin 2012, 01:03 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 11 juin 2012, 01:03 UTC−4
Hi

probably you have some parasitic capacity loss that offsets your signal, or could it be some low conductance ?
It seems to drift too, so have you taken the fall time ? and checked if its not a initial value transient ?

--
Good luck
Ivar
Hi probably you have some parasitic capacity loss that offsets your signal, or could it be some low conductance ? It seems to drift too, so have you taken the fall time ? and checked if its not a initial value transient ? -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.