Menu

Discussion Forum

New Discussion
Filtrer

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

20 degrees phase shift

Posted 28 mai 2012, 06:02 UTC−4 MEMS & Nanotechnology, RF & Microwave Engineering, MEMS & Piezoelectric Devices, Modeling Tools & Definitions, Parameters, Variables, & Functions 3 Replies

RAJASEKHAR ATLA
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

If i want to give 90 degrees phase shift simply i can give "i" ,but if i want 20 degrees phase shift can i apply simply "i-70",will it work
3 Replies Last Post 28 mai 2012, 08:40 UTC−4
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 28 mai 2012, 06:26 UTC−4
Hi

the phasor approach is in radians not in degrees, so use rather:

V0*exp(i*pi*Phase_in_degrees/180)

By the way you should check the sign convention, if you use a + or a - in front of your "i"


--
Good luck
Ivar
Hi the phasor approach is in radians not in degrees, so use rather: V0*exp(i*pi*Phase_in_degrees/180) By the way you should check the sign convention, if you use a + or a - in front of your "i" -- Good luck Ivar
RAJASEKHAR ATLA
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 28 mai 2012, 08:34 UTC−4
Instead of this may give like this

90 degrees=exp(j*pi/2)

45 degrees=exp(j*pi/4)

is it correct
Instead of this may give like this 90 degrees=exp(j*pi/2) 45 degrees=exp(j*pi/4) is it correct
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 28 mai 2012, 08:40 UTC−4
Hi

That look s fine, normally i and j are synonymes (try it out in a parameter field of COMSOL)

--
Good luck
Ivar
Hi That look s fine, normally i and j are synonymes (try it out in a parameter field of COMSOL) -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content