Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
interior wall problem
Posted 26 avr. 2021, 08:12 UTC−4 Fluid & Heat, Computational Fluid Dynamics (CFD) Version 5.5 0 Replies
Please login with a confirmed email address before reporting spam
I am studying heart valve simulation. I have got the problem to simulate the heart valve using the Comsol software. I am looking for some advice on the Comsol software.
As for the current research progress, the heart and valve were separately implemented, and they were assembled and imported to run the simulation. When conditions are entered and executed, they are simulated ignoring the valve. If you set the interior wall for this, it is expected that the valve will be recognized and simulated. But it doesn't recognize the interior wall. I have attached the file about the problem so that you can have a look at it. It would be very helpful if you could give me some suggestions and advice.
Attachments:
Hello Jeonglim Choi
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.