Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
error 4100??
Posted 25 janv. 2010, 22:22 UTC−5 1 Reply
Please login with a confirmed email address before reporting spam
hi guys, I want to ask you about the error I found in my COMSOL, it's says:
Error: 4100
Failed to generate mesh for subdomain.
- Subdomain: 1
Failed to respect boundary element edge on geometry face.
- Face: 6
- x coordinate: -0.0228125
- y coordinate: 0.279526
- z coordinate: -0.0005
Internal error in boundary respecting.
So what should I do and why is this error happening? I want to make a structure using the composite objects, but this error come to the surface. Thanks for your attention.
Error: 4100
Failed to generate mesh for subdomain.
- Subdomain: 1
Failed to respect boundary element edge on geometry face.
- Face: 6
- x coordinate: -0.0228125
- y coordinate: 0.279526
- z coordinate: -0.0005
Internal error in boundary respecting.
So what should I do and why is this error happening? I want to make a structure using the composite objects, but this error come to the surface. Thanks for your attention.
1 Reply Last Post 26 janv. 2010, 03:29 UTC−5
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
often you can get around by meshing edges/faces by hand, removing "small" features in the geometry (if not relevant to the solution) or cut the volumes into smaller parts to allow the mesher to better adapt to complex geometry shapes.
Try also to change the default meshing size, or adapt it for the different parts
Try to understand where and what is getting wrong by studying the geometry around that coordinate (and any similar shaped element in your model).
Automatic meshing of complex geometries is not trivial, not even for a human ;)
Good luck
Ivar
often you can get around by meshing edges/faces by hand, removing "small" features in the geometry (if not relevant to the solution) or cut the volumes into smaller parts to allow the mesher to better adapt to complex geometry shapes.
Try also to change the default meshing size, or adapt it for the different parts
Try to understand where and what is getting wrong by studying the geometry around that coordinate (and any similar shaped element in your model).
Automatic meshing of complex geometries is not trivial, not even for a human ;)
Good luck
Ivar