Menu

Discussion Forum

New Discussion
Filtrer

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

post-processing in matlab - how to call the solutions?

Posted 21 avr. 2012, 19:18 UTC−4 Results & Visualization, Studies & Solvers Version 4.2a 0 Replies

Sirisha Govindaraju
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have 3 different studies in a single model file and lets say solution1 corresponds to study 1, solution2 corresponds to study2 etc.

If I am using matlab for postprocessing, what command should I use to refer to solution 2?
Is it dset2 or 'solution','2'?

Thanks,
Sirisha
0 Replies Last Post 21 avr. 2012, 19:18 UTC−4
COMSOL Moderator

Hello Sirisha Govindaraju

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content